The Heads on Fire Community

Electrical Schematic:

Writing up schematic is important part in setting up a working circuit.  The first part in linking up is starting from MOSFET it has three prongs that are called GDS. You are only allowed to use holes that are unfilled. Then you connect it to resistor and make sure that the GS aren't in the same row. The D connects to postive end of LED and then connects to 1 K Ohm, the 1 K Ohm then is connected to copper panels. Slot S in mosfet connects to 500 K Ohm, and also the negative side of battery terminal. The G then is looped around to 500 K Ohm resistor, where resistor then holds hand with copper panel. The resistor is like a cop that sets up routine checkup if person is going faster then required speed they will get pulled over. The MOSFET amplifies energy so if 1 watt goes into system then it will produce 100 watt of energy.